Diagnostic Test
- CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
- Turn the ignition on.
- Press each Remote Radio Switch twice.
- With the scan tool, read DTCs
Does the scan tool display this DTC as active?
Yes
- Replace the Right Steering Wheel Control Switch (Speed Control Switch) in accordance with the Service Information. Once the switch has been replaced, press it twice to initialize it.
- Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.
WARNING:Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
WARNING:Do not place an intact non-deployed airbag face down on a hard surface, the airbag propels into the air if accidentally deployed. Failure to follow these instructions may result in possible serious or fatal injury.
NOTE:Check for a stuck Remote Radio Switch. Repair as necessary.
NOTE:Visually and physically inspect the wiring harness between the Remote Radio Switch harness connectors and the Right Steering Wheel Switch (Speed Control Switch) harness connector. Repair any damaged wires, connectors, and open/spread terminals. If harness is OK, proceed with test.
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.