Pcm/TCM Flash Reprogramming

This procedure is required when one or more of the following situations are true:

1. A Powertrain Control Module (PCM) has been replaced.
2. Diagnostic Trouble Code (DTC) P1602 - PCM Not Programmed is set.
3. An updated calibration or software release is available for either the PCM or TCM.

This procedure assumes that the wiTECH™ VCI Pod and StarMOBILE® devices are properly configured to the dealership's network with either a wired or wireless connection. The wiTECH™ VCI Pod and StarMOBILE® must also be running the latest operating system and software release. For help on how to network the StarMOBILE®, reference the appropriate Quick Start Networking Guide available on 'DealerCONNECT > Service > StarSCAN® and StarMOBILE® Tools > Online Documentation' or at www.dcctools.com, under the Download Center. For help on how to network the wiTECH™ VCI Pod, use the "Help" tab at the top of the wiTECH™ Diagnostic Application.