Diagnostic Test
- CHECK FOR BCM CAN BUS DTCS
- With the scan tool, read BCM DTCs.
Are there any BCM CAN BUS DTCS present?
Yes
- Refer to Diagnosis and Testing and perform the appropriate symptom.
- Perform the NAG1 TRANSMISSION VERIFICATION TEST. Refer to Standard Procedure .
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM in accordance with the Service Information.
- Perform the NAG1 TRANSMISSION VERIFICATION TEST. Refer to Standard Procedure .
- With the scan tool, read BCM DTCs.