Diagnostic Test

WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

CHECK IF TCM IS FLASHABLE
1. With the scan tool, record the vehicles TCM and PCM/ECM part numbers.
2. Verify the model year and make of both the TCM and ECM/PCM part numbers.
3. Flash and program the controller(s) with the correct software that corresponds with year and make of the vehicle. Refer to the Service Information for proper programing procedures.
  Were you able to update (flash) the controller(s) successfully to the proper software levels?
  
  Yes
  - Test Complete.
  - Perform NAG1 TRANSMISSION VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure .
  No
  - Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCM in accordance to the Service Information.
  - Perform NAG1 TRANSMISSION VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure