Diagnostic Test
WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR TIPM CAN BUS DTCS
- With the scan tool, read TIPM DTCs.
Are there any TIPM CAN BUS DTCs present?
Yes
- Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Diagnosis and Testing for diagnostic procedures and other possible causes.
- Perform NAG1 TRANSMISSION VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure .
No
- Go to step 2.
- With the scan tool, read TIPM DTCs.
- ELECTRONIC SHIFT MODULE DTCS PRESENT
- With the scan tool, read Electronic Shift Module (ESM) DTCs.
Are there any ESM DTCs present?
Yes
- Refer to DTC Based Diagnostics and perform the appropriate diagnostic procedure.
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM in accordance with the Service Information.
- Perform NAG1 TRANSMISSION VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure .
- With the scan tool, read Electronic Shift Module (ESM) DTCs.