Intermittent Condition, Pre-Diagnostic Troubleshooting Procedure, Pcm/TCM Programming & Powertrain Verification Test
- Standard Procedure
- Intermittent Condition
- Pre-Diagnostic Troubleshooting Procedure
- Pcm / TCM Programming
- Pcm / TCM Flash PROGRAMING
- Table Of Contents
- Section 1 - Pcm / TCM Flash Procedure
- Repair Procedure - Using STARSCAN® Or STARMOBILE® Desktop Client
- Repair Procedure - WITECH™ Diagnostic Application
- Section 2 - Additional Pcm / TCM Replacement Procedures
- Notes
- If an EDC16-U31 PCM/ECM (2.0L) was replaced, perform the following additional steps and/or routines:
- If an EDC16-C2 PCM/ECM (2.2L) was replaced, perform the following additional steps and/or routines:
- If an EDC16-CP31 (3.0L) was replaced, perform the following additional steps and/or routines:
- If an EDC16-CP31-2 (2.8L) was replaced, perform the following additional steps and/or routines:
- If a CM849 PCM/ECM (5.9L) was replaced, perform the following additional steps and/or routines:
- If a CM2100 PCM/ECM (6.7L) was replaced, perform the following additional steps and/or routines:
- TCM Replacement
- If an EGS TCM was replaced, perform the following additional steps and/or routines:
- Step-By-Step Instructions
- Section 3 - Authorized Modification Label
- Required Tools/Equipment:
- Tech Tips And Information:
- Parts Required
- Powertrain Verification Test