Diagnostic Test

CHECK FOR ACTIVE DTC
NOTE:
Diagnose any ABS Module DTCs before proceeding with the test.
1. Turn the ignition on.
2. With the scan tool, read BSM DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Replace the ABS Module in accordance with the Service Information.
  - Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.
  No
  - The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
  - Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.