Programming The Pcm

WARNING: This page is about a different car, the 2011 Dodge Grand Caravan and 2011 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.

The secret key is an ID code that is unique to each WIN. This code is programmed and stored in the WIN, the PCM, and each ignition key transponder chip. When the PCM or WIN is replaced, it is necessary to program the Secret Key Code into the new module using a diagnostic scan tool. Follow the programming steps outlined in the diagnostic scan tool for PCM REPLACED , WIN REPLACED , or TIPM REPLACED under MISCELLANEOUS FUNCTIONS for the WIRELESS CONTROL MODULE menu item as appropriate.

NOTE:

Programming the PCM or WIN is done using a diagnostic scan tool and a PIN to enter secure access mode. If three attempts are made to enter secure access mode using an incorrect PIN, secure access mode will be locked out for one hour. To exit this lockout mode, turn the ignition to the RUN position for one hour and then enter the correct PIN. Be certain that all accessories are turned OFF. Also, monitor the battery state and connect a battery charger if necessary.

CAUTION:

Read all notes and cautions for programming procedures.

NOTE:

If you are also replacing the WCM/WIN and/or Ignition Keys/FOBIKS refer to the module/programming order replacement guide before starting. Refer to STANDARD PROCEDURE .

Connect a battery charger to the vehicle.
Connect the scan tool.
Have a unique vehicle PIN readily available before running the routine.
Ignition key should be in RUN position.
Select "ECU View".
Select "WIN Wireless Control".
Select "Miscellaneous Functions."
Select "PCM Replaced".
Enter the PIN when prompted.
Verify the correct information.
Cycle ignition key after the successful routine completion.