Diagnostic Test

CHECK IF THE DTC IS ACTIVE
1. With the scan tool, read Transmission DTCs.
  Is the status Active for this DTC?
  
  Yes
  - Go To 2.
  No
  - Go To 4.
CHECK THE TIPM
Has the TIPM been reprogrammed (tire size) or replaced without being programed?

Yes
- Program the TIPM if not programed. If the tire size was changed, with the scan tool perform a Initialize CVT procedure.
- Refer to STANDARD PROCEDURE and perform the CVT VERIFICATION TEST.
No
- Go To 3.
CHECK THE TCM
Has the TCM been recently replaced with a new or used controller?

Yes
- With the scan tool perform a TCM relearn.
- Refer to STANDARD PROCEDURE and perform the CVT VERIFICATION TEST.
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. Check for any Service Bulletins for possible causes that may apply. If no problems are found, replace the TCM in accordance with the Service Information.
- Refer to STANDARD PROCEDURE and perform the CVT VERIFICATION TEST.
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
3. Wiggle the wires while checking for shorted and open circuits.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Refer to STANDARD PROCEDURE and perform the CVT VERIFICATION TEST.
  No
  - Test Complete.