Sensor, Intrusion Module, Export: Removal: Transmitter

Fig 1: Remove/Install Bezel

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the battery negative cable.
2. If replacing the bezel, pull the bezel (1) inboard from the C-pillar (3), or use a trim stick or equivalent to unsnap it from the transducer housing (2) of the intrusion sensor transmitter.
3. Remove the C-pillar trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL .
4. Remove the two retaining screws from the C-pillar and remove the sensor.