Diagnostic Test

CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
1. Turn the ignition on.
2. With the scan tool, read Park Assist Module DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2.
  No
  - The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
  - Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.
VERIFY ABS IS ACTIVE ON THE CAN BUS
1. With the scan tool, select ECU View.
2. Verify that the ABS is active on the bus.
  Is the ABS active on the bus?
  
  Yes
  - Go To 3.
  No
  - Refer to DIAGNOSIS AND TESTING and perform the No Response from ABS diagnostic procedure.
  - Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.
DTCS STORED OR ACTIVE IN THE ANTILOCK BRAKE MODULE (ABS)
1. With the scan tool, read ABS DTCs.
  Are any DTCs active or stored in the ABS?
  
  Yes
  - Refer to DIAGNOSIS AND TESTING or DIAGNOSIS AND TESTING for SRT8 and perform the appropriate diagnostic procedure .
  No
  - Go To 4.
ACTIVE COMMUNICATION DTCS IN THE TIPM
1. With the scan tool, select ECU View and select TIPM.
2. With the scan tool, read active DTCs.
  Are any Communication DTCs active in the TIPM?
  
  Yes
  - Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
  No
  - Replace and program the Park Assist Module in accordance with the Service Information. Refer to MODULE, PARK ASSIST, EMOVAL .
  - Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.