LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2012 >> Charger SRT-8 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Transmission Control Module (TCM) - Pre-Diagnostic Troubleshooting Procedure, Transmission Verification Test, TCM Programming Procedure & TCM Adaptation - 8HP45 Automatic Transmission) >> Standard Procedure >> Transmission Verification Test >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Verification Test: Notes

WARNING: This page is about a different variant/trim than selected.

To validate the repair(s) that fixed the vehicle, perform the following steps.

  1. Reconnect any disconnected components.
  2. Connect the scan tool to the Data Link Connector.
  3. With the scan tool, erase ABS DTCs.
  4. With the scan tool, erase PCM DTCs.
  5. With the scan tool, erase TCM DTCs.
    CAUTION:

    Apply the parking brake.

  6. With the scan tool, display the Transmission Temperature. Start and run the engine until the transmission temperature is above 43° C (110° F).
  7. If internal transmission components were repaired or replaced check the transmission fluid and adjust if necessary. Refer to FLUID AND FILTER, STANDARD PROCEDURE and perform the CHECK OIL LEVEL procedure.
  8. If internal transmission repairs are performed or the Transmission Control Module Assembly (TCMA) is replaced, refer to STANDARD PROCEDURE and perform a TCM ADAPTATION procedure.
  9. After performing the above procedures, perform the Road Test Procedure. 
scientia non olet · About LEMON Manuals