Memory Seat Module - Removal

REMOVAL

NOTE: The scan tool standardization process must be performed on the Memory Seat Module (MSM) any time a new MSM is installed or the existing MSM is reflashed.






NOTE: Depending on how equipped, more memory seat module electrical connectors may be present than shown in the illustration.

1. Disconnect and isolate the negative battery cable.
2. Remove the fasteners that secure the driver seat to the body and tip the seat rearward to gain access to the underneath of the seat Service and Repair.
3. Disconnect the electrical connectors (3 and 6) from the Memory Seat Module (MSM) (1).
4. Disengage the two rear MSM retaining tabs (5 and 7) from the bracket (8) by carefully pushing the rear of the MSM upward.
5. Disengage the two front MSM retaining tabs (2 and 4) from the bracket by pulling the MSM rearward.
6. Remove the MSM from underneath the driver seat.