Anti-Lock Brake System Module - Removal

REMOVAL






NOTE: LHD shown, RHD similar.

1. Remove and isolate the negative battery cable from the battery.
2. Remove the air cleaner body.
3. Disconnect the HCU electrical connector (3).





4. Remove the four ABS module retaining screws (3).






CAUTION: When removing the ABS module from the HCU, be sure to completely separate the two components approximately 38 mm (1.5 in.) straight out before moving module to the side. Otherwise, damage to the pressure sensor or Pump Motor connection may result requiring HCU replacement. Do not to touch the sensor terminals on the module side or the contact pads on the HCU side as this may result in contamination and issues in the future.

5. Pull the ABS module (3) straight out to the brake lines (4), move toward the outside of the vehicle, then forward and around the brake lines (4) to remove the ABS module (3) from the vehicle.