LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2012 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Electronic Control Modules (Service Information)) >> Module, Powertrain Control >> Standard Procedure >> Pcm/ECM / TCM Programming >> Repair Procedure - WITECH™ Diagnostic Application
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedure - WITECH™ Diagnostic Application

WARNING: This page is about a different car, the 2012 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If this flash process is interrupted or aborted, the flash should be restarted.

  1. Open the hood of the vehicle and install a battery charger. Verify that the charging rate provides a continuous charge of 13.2 - 13.5 Volts.
  2. Connect the wiTECH™ Vehicle Connection Interface (VCI) pod to the vehicle data link connector located under the steering column and turn the ignition key to the "RUN" position.
  3. Launch the wiTECH™ Diagnostic Application and connect to the appropriate wiTECH™ device.
  4. From the wiTECH™ Diagnostic Application Home screen,
    1. Select "HELP"
    2. Select "HELP CONTENTS"
    3. Follow the "HELP TOPIC" for flashing an ECU.
scientia non olet · About LEMON Manuals