Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR CAN BUS DTCS
- With the scan tool, check for CAN DTCs.
Are there any CAN BUS DTCs present?
Yes
- Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
- Refer to STANDARD PROCEDURE and perform the NAG1 TRANSMISSION VERIFICATION TEST.
No
- Go To 2.
- With the scan tool, check for CAN DTCs.
- ELECTRONIC SHIFT MODULE DTCS PRESENT
- With the scan tool, read Electronic Shift Module (ESM) DTCs.
Are there any ESM DTCs present?
Yes
- Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
- Refer to STANDARD PROCEDURE and perform the NAG1 TRANSMISSION VERIFICATION TEST.
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCM in accordance with the Service Information.
- Refer to STANDARD PROCEDURE and perform the NAG1 TRANSMISSION VERIFICATION TEST.
- With the scan tool, read Electronic Shift Module (ESM) DTCs.