Erasing Transmitter Codes
WARNING: This page is about a different car, the 2012 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Individual channels (buttons) cannot be erased. Erasing the transmitter codes will erase ALL programmed codes.
To erase programming from the three transmitter buttons:
- Press and hold the two outer HomeLink® buttons until the indicator light begins to flash (about 20 seconds). Do not hold the buttons for longer that 30 seconds.
- Release both buttons.
- HomeLink® is now in the train (or learning) mode and can be programmed at any time using the Programming standard procedure. Refer to STANDARD PROCEDURE .