A/C And Heater Control Module - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.





1. Disconnect and isolate the negative battery cable.
2. Remove the center bezel from the instrument panel Instrument Panel Center Bezel - Removal
3. Remove the four screws (1 and 3) that secure the A/C heater module (2) to the instrument panel support (4).





4. Disconnect the two wire harness connectors (2) and remove the A/C heater module (1) from the instrument panel support (3).