Diagnostic Test

REPLACE ELECTRONIC PEDESTRIAN PROTECTION MODULE (EPPM)
1. Turn the ignition on.
2. With the scan tool, erase and read EPPM DTCs.
  WARNING:
  Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
  
  WARNING:
  If the Electronic Pedestrian Protection Module (EPPM) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental actuator deployment. Failure to follow these instructions may result in possible serious or fatal injury.
  
  When this code is set, view repair.
  
  Repair
  - Replace the Electronic Pedestrian Protection Module (EPPM) in accordance with the Service Information. Refer to MODULE, ELECTRONIC PEDESTRIAN PROTECTION, REMOVAL .
  - Refer to STANDARD PROCEDURE and perform the EPPM SYSTEM VERIFICATION TEST.