LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2012 >> Ram Cargo Van V6-3.6L >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Lighting and Horns >> Headlamp Alignment Control Module >> Service and Repair >> Headlamp Leveling Module - Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Headlamp Leveling Module - Installation





INSTALLATION





1. Position the Automatic Headlamp Leveling Module (AHLM) (also known as the High Intensity Discharge Transducer/HIDT) (1) and mounting strap over the studs on the top of the left inner rear wheel housing (3) as a unit.
2. Install and tighten the two nuts (2) that secure the mounting strap of the AHLM to the two studs on the top of the left inner rear wheel housing. Tighten the nuts to 11 Nm (8 ft. lbs.).
3. Reconnect the body wire harness connector to the connector receptacle of the AHLM.
4. Reinstall the trim onto the left quarter inner panel. Quarter Trim Panel - Installation.
5. Reconnect the battery negative cable.

scientia non olet · About LEMON Manuals