LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2013 >> Challenger SXT Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 1634 (Module Configuration System) >> General Procedures >> Accessory Protocol Interface Module (APIM) Programming >> Accessory Protocol Interface Module (APIM) Programming Using the Integrated Diagnostic System (IDS)
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Accessory Protocol Interface Module (APIM) Programming Using the Integrated Diagnostic System (IDS)

WARNING: This page is about a different car, the 2012 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If a new Accessory Protocol Interface Module (APIM) is being installed, install a new APIM before carrying out the following procedure. For additional information, refer to INFORMATION AND ENTERTAINMENT SYSTEMS article.
  • When carrying out the programming procedures, follow the scan tool on-screen directions.
  • Make sure the battery is fully charged before carrying out the programming steps.
  • A hardwired internet connection is strongly recommended when programming.
NOTE:
  • For APIM flash programming:
    • The scan tool and a USB male A to male A cable (CCMUSB2-AM-AM-10 or equivalent) are required.
    • The flash procedure deletes any paired phones that were in the SYNC® system.
    • The file for the flash needs to be downloaded from the on-line database. Allow for extra time for the file to download. The files are approximately 80 megabyte.
scientia non olet · About LEMON Manuals