Module, Heated Seat: Installation: Installation

WARNING: This page is about a different car, the 2012 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

When equipped with a leather wrapped heated steering wheel and replacement of a Heated Seat Module (HSM) is required, the new HSM must be manually configured with a scan tool. Refer to STANDARD PROCEDURE . Failure to follow these instruction may result in damage to the heated steering wheel.

CAUTION:

Properly align the Heated Seat Module (HSM) retaining tabs to the bracket, prior to engagement. Failure to follow these instructions may result in damage to the HSM.

Fig 1: Electrical Connectors, Heated Seat Module (HSM), Retaining Tab, Bracket & Two Retaining Tabs

Courtesy of CHRYSLER GROUP, LLC

Position the Heated Seat Module (HSM) (4) to the bracket (7) and engage the two retaining tabs (6). Make sure the retaining tabs are correctly engaged to the bracket.
Engage the HSM retaining tab (3) to the bracket. Make sure the retaining tab is fully engaged to the bracket.
Connect the electrical connectors (1, 2 and 5) to the HSM.

Fig 2: Two Bolts, Bracket & Heated Seat Module (HSM)
Courtesy of CHRYSLER GROUP, LLC
Position the bracket (2) containing the HSM (3) to the underside of the seat cushion frame (4) and engage the metal bracket retaining tab (5) to the seat cushion frame.
Install the two bolts (1) that secure the bracket to the underside of the seat cushion frame. Tighten the bolts securely.
Install the seat. Refer to SEAT, SECOND ROW, INSTALLATION or SEAT, THIRD ROW, INSTALLATION or SEAT, FRONT, INSTALLATION .
Reconnect the negative battery cable.
When equipped with leather wrapped heated steering wheel, use a scan tool and configure the HSM. Refer to STANDARD PROCEDURE .