Diagnostic Test

WARNING: This page is about a different car, the 2013 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

TEST FOR INTERMITTENT CONDITION
NOTE:
All FOBIKs used with this vehicle should be present during this test.

NOTE:
Verify that the battery is fully charged with a DVOM and use the scan tool to compare the Battery Voltage listed under "Data" in the RFH View to that of the BCM. If the battery is not fully charged, correct this condition before proceeding.
1. With one of the owners good FOBIKs, turn the ignition on.
2. With the scan tool, record and erase the DTCs.
3. Operate the alleged inoperative FOBIK in all positions several times.
4. With the scan tool, read the DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2.
  No
  - The conditions that caused this code to set are not present at this time. The FOBIK may have already been re-synchronized by being in the vehicle while it was being driven. Inform the owner of the most probable cause for this code to set and therefore causing the FOBIK to be inoperative.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
TEST DRIVE THE VEHICLE
1. With the scan tool, erase the DTCs.
2. Turn the ignition off.
3. Put the inoperative FOBIK in the vehicle.
4. With the good FOBIK, start and drive the vehicle above five miles per hour for one mile.
5. Turn the ignition off.
6. Operate the inoperative FOBIK in all positions several times.
7. With the scan tool, read the DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Replace the FOBIK and program using the scan tool.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test complete.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .