Diagnostic Test

WARNING: This page is about a different car, the 2013 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2.
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
(F927) RUN RELAY OUTPUT CIRCUIT OPEN OR SHORTED TO GROUND
1. Turn the ignition off.
2. Disconnect the Right Front Lamp Assembly C1 harness connector.
3. Turn the ignition on.
4. Measure the voltage of the (F927) Run Relay Output circuit.
  Is the voltage greater than 10.0 volts?
  
  Yes
  - Go To 3.
  No
  - Repair the (F927) Run Relay Output circuit for an open or short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
(Z902) GROUND CIRCUITS OPEN
1. Turn the ignition off.
2. Measure the resistance between ground and the (Z902) Ground circuits.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Go To 4.
  No
  - Repair the open in the (Z902) Ground circuits.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
MEASURE THE VOLTAGE OF THE (D412) LIN BUS CIRCUIT
1. Turn the ignition on.
2. Measure the voltage of the (D412) LIN BUS circuit.
  Is voltage present?
  
  Yes
  - Replace the Right Headlamp Assembly in accordance with the Service Information. Refer to UNIT, FRONT LAMP, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 5.
(D412) LIN BUS CIRCUIT SHORTED TO GROUND
1. Turn the ignition off.
2. Disconnect the Adaptive Front Lighting System (AFLS) Module harness connector.
3. Measure the resistance between ground and the (D412) LIN BUS circuit.
  Is the resistance below 10K Ohms?
  
  Yes
  - Repair the short to ground in the (D412) LIN BUS circuit.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 6.
(D412) LIN BUS CIRCUIT OPEN
1. Measure the resistance of the (D412) LIN BUS circuit.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Replace the Adaptive Front Lighting System (AFLS) Module in accordance with the Service Information. Refer to MODULE, ADAPTIVE FRONT LIGHTING SYSTEM, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Repair the open in the (D412) LIN BUS circuit.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .