Restore Vehicle Configuration
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The technician should have cut the KEY FOBIK Blanks using the original vehicle's Key FOBIK as a template. Please make sure the KEY FOBIK Blanks have been cut prior to programming. If this step has not been performed, please perform at this time.
CAUTION:
Read all notes and cautions for programming procedures.
NOTE:
Prior to programming, have the vehicle PIN readily available before running the routine. If necessary, obtain the four digit PIN from the dealership's parts department.
CAUTION:
If the PCM and WCM are replaced at the same time, the PCM MUST be programmed before the WCM.
- When prompted, enter the four digit pin number obtained from the dealership parts department.
- Connect a battery charger to the vehicle.
- With the wiTECH diagnostic application, perform the following steps form the Initial Start Up Screen:
- Select the "DIAGNOSTIC PROCEDURES" tab
- Highlight "RESTORE VEHICLE CONFIGURATION"
- Select the "Run Diagnostic" button
- Select "CONTINUE"
- Verify that the vehicle VIN number is correct
- Once verified, select the "Correct VIN" button
- Note On-Screen instructions and select the "Close" button