Update Pressure Thresholds
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The wiTECH software level must be at the latest release to perform this procedure.
NOTE:
The vehicle must be driven before the TPMS light will turn off.
CAUTION:
Read all notes and cautions for programming procedures.
NOTE:
Have the vehicle PIN readily available before running the routine
- Connect a battery charger to the vehicle.
- With the wiTECH diagnostic application, perform the following steps:
- Select "WIRELESS CONTROL MODULE (WCM)"
- Select the "MISCELLANEOUS FUNCTIONS" tab
- Highlight and select "UPDATE PRESSURE THRESHOLDS"
- Note On-Screen instructions and select the "NEXT" button
- Verify current settings, select the "NEXT" button to change settings
- Select "NEXT"
- Enter the PIN when prompted.
- Select "NEXT"
- Verify that the PIN number is correct
- Once verified, select "NEXT"
- Select "NEXT"
- Wait for the WCM to update it's configuration
- Once the WCM configuration is complete, select "NEXT"
- Note On-Screen instructions and select the "FINISH" button