LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2013 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 589 (Electronic Control Modules (Service Information)) >> Module, HVAC >> Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, HVAC: Installation: Installation

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Illustration shown with instrument panel removed from view for clarity.

Fig 1: Wire Harness Connector, A/C Heater Module & Air Inlet Housing
GC0144553Courtesy of CHRYSLER GROUP, LLC
  1. Position the HVAC module (1) to the air inlet housing (4) and engage the module to the two front retaining screws (2).
  2. Loosely install the screw (5) that secures the rear of the HVAC module to the air inlet housing.
  3. Tighten all the screws that secure the HVAC module to the air inlet housing to 2 N.m (17 in. lbs.).
  4. Connect the wire harness connector (3) to the HVAC module.
  5. Install the glove box trim panel and glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
  6. Install the right side instrument panel silencer. Refer to PANEL, SILENCER, INSTALLATION .
  7. Reconnect the negative battery cable.
  8. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals