Diagnostic Test

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

DTCM VERIFICATION TEST
1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
2. With the scan tool, erase DTCs.
3. Make sure that all accessories are turned off and that the battery is fully charged.
4. Test drive the vehicle and verify proper operation.
5. With the scan tool, read DTCs in the DTCM.
  Are there any DTCs present in the Drive Train Control Module (DTCM)?
  
  Yes
  - Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
  No
  - Repair is complete.