LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2013 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 823 (Electronic Control Modules (Service Information)) >> Module, Park Assist (PAM) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Park Assist (PAM): Removal

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
GC0144523Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
  2. Remove the trunk close out trim panel and the right quarter trim panel to access the Park Assist Module (PAM) (1). Refer to PANEL, TRUNK TRIM, REAR, REMOVAL .
  3. Disconnect the wire harness connectors (2) from the PAM.
  4. Remove the retainers (3) that secure the PAM to the quarter inner panel.
  5. Slide the PAM upward far enough to disengage the lower mounting tab from the stamped pocket in the right quarter inner panel.
  6. Remove the PAM from the vehicle.
scientia non olet · About LEMON Manuals