LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2013 >> Durango SXT, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Transmission Control >> Standard Procedure >> Drive Learn - 5.7L Vehicles >> Learn A Smooth 1ST Neutral To Drive Shift
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Learn A Smooth 1ST Neutral To Drive Shift

Perform this procedure only if the complaint is for a delayed or harsh shift the first time the transmission is put into gear after the vehicle is allowed to set with the engine not running for at least 10 minutes. Use the following steps to have the TCM learn the 1st N-D UD CVI.

NOTE:

The transmission oil temperature must be between 27-43° C (80-110° F).

  1. Start the engine only when the engine and ignition have been off for at least ten (10) minutes.
  2. With the vehicle at a stop and the service brake applied, record the 1st N-D UD CVI while performing a Neutral to Drive shift. The 1st N-D UD CVI accounts for air entrapment in the UD clutch that may occur after the engine has been off for a period of time.
  3. Repeat and refer to  1 until the recorded 1st N-D UD CVI value stabilizes. Then refer to  2.
scientia non olet · About LEMON Manuals