Module, Memory: Removal: Removal

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Anytime a Memory Seat Module (MSM) is replaced, the MSM must be cleared of all learned parameters using a scan tool, and the Power Seat System Verification test must be performed.

NOTE:

Depending on how equipped, more memory seat module electrical connectors may be present than shown in the illustration.

Fig 1: Electrical Connectors, Memory Seat Module (MSM), MSM Retaining Tabs & Bracket

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the battery negative cable.
Remove the fasteners that secure the driver seat to the body and tip the seat rearward to gain access to the underneath of the seat. Refer to SEAT, FRONT, REMOVAL .
Disconnect all the electrical connectors (1) from the front of the Memory Seat Module (MSM) (2).
Disengage the two front MSM retaining tabs (3 and 5) from the bracket (4) by carefully pushing up on the front of the MSM.
Disengage the two rear MSM retaining tabs from the bracket by carefully pulling the MSM forward.
Disconnect all electrical connectors from the rear of the MSM and remove the MSM.