Module, Hands Free: Removal: Removal

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Trim Piece & Connectors

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Remove the HVAC control panel. Refer to CONTROL, A/C AND HEATER, REMOVAL .
Remove the trim piece (3) in front of the Hands Free Module (HFM) to access the connectors (1 and 2).

Fig 2: Connector & USB Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the electrical connector (2) from the HFM and the USB connector (1) if equipped.
Remove the hands free module mounting fasteners.
Remove the HFM from the vehicle.