Module, Active Damping Control: Installation: Installation
WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
- Place the Active Damping Control Module (ADCM) (3) into position and install the four ADCM retaining screws (2). Tighten to the proper specification.
- Install the retaining screws (2) and tighten to 9 N.m (80 in. lbs.).
- Connect the wire harness connectors (1) to the ADCM (3). Install the inner left rear wheel well carpet. Refer to CARPET, INSTALLATION .
- Connect the negative battery cable.
- Perform the ADCM Verification Test. Refer to ADCM VERIFICATION TEST .