Module And Bracket

WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.

Check to be certain that the two rivet nuts are properly installed and in good condition in front bumper support bar.
Position the mounting bracket to the bumper support bar.

Fig 1: Adaptive Cruise Control Module Bracket & Screws
Courtesy of CHRYSLER GROUP, LLC
Install and tighten the two screws (2) that secure the mounting bracket (1) to the support bar. Tighten the screws to the proper specification. Refer to SPECIFICATIONS .
Install the energy absorber.

Fig 2: Adaptive Cruise Control Module Connector
Courtesy of CHRYSLER GROUP, LLC
Connect the wiring harness connector (1) to the ACC sensor module.
Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .
Connect the negative battery cable.
Perform the ACC module alignment procedure. Refer to MODULE, ADAPTIVE CRUISE CONTROL, MODULE PROGRAMMING .