Sunroof Motor And Module Initialization: REINITIALIZATION
WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
The following procedure causes a previously calibrated and properly operating electronic motor module to relearn and update motor stall position and obstacle detection.
NOTE:
If at any point during the following procedure the sunroof does not respond as expected, restart the procedure at Step 1.
- Depress and hold the CLOSE push button of the sunroof switch until the sliding glass panel is fully closed.
- Continue to hold the CLOSE push button of the sunroof switch. It will take at least 10 seconds for the initialization process to begin.
- The sunroof sliding glass panel will move to the hard stop and then back to the tilt (VENT) position.
- Release the CLOSE push button of the sunroof switch, then depress and hold the CLOSE push button again within 5 seconds.
- As the CLOSE push button of the sunroof switch is held, the sunroof sliding glass panel will move to the fully closed position, then to the fully opened position and then fully closed again.
- Initialization is complete. Release the sunroof switch push button.