LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2013 >> Durango SXT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 698 (Electronic Control Modules (Service Information)) >> Module, Transmission Control >> Module Programming >> Programming The Transmission Control Module (TCM)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming The Transmission Control Module (TCM)

WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

New Transmission Control Modules (TCMs) are supplied with generic software. When replacing a TCM, it must be programmed with vehicle specific software.

NOTE:

Failure to properly program the TCM will cause DTC(s) to be set.

  1. The following conditions must be met during the reprogramming procedure:
    • Battery must be maintained between 10 and 16 volts. Connect a battery charger if necessary.
    • Ambient temperature must be between 0°C (32°F) 60°C (140°F).
    • Gear Selector must be in PARK.
  2. With the scan tool and Dealer Connect, download the appropriate TCM flash file to the scan tool.
  3. Turn the ignition on.
  4. Following the menu on the scan tool, program the TCM.
  5. Perform the TCM ADAPTATION procedure. Refer to MODULE, TRANSMISSION CONTROL, MODULE PROGRAMMING .
  6. Perform the TRANSMISSION VERIFICATION TEST. Refer to the appropriate diagnostic & testing article. .
scientia non olet · About LEMON Manuals