LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2013 >> Durango SXT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 823 (Electronic Control Modules (Service Information)) >> Module, Door (DDM/PDM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Door (DDM/PDM): Installation

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
GC0144728Courtesy of CHRYSLER GROUP, LLC
  1. Position the door control module (2) to the front door hardware module carrier (1).
  2. Install and tighten the fasteners (4) that secure the door control module to the front door hardware module carrier. Tighten the fasteners securely.
  3. Connect the wire harness connectors (3) to the door control module.
  4. Install the trim panel to the inside of the front door. Refer to PANEL, DOOR TRIM, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  6. The manual relearn procedure should be performed following service of a door control module so that the module can learn the correct hard stops of the power window regulator. Refer to DOOR MODULE LEARN PROCEDURES .
scientia non olet · About LEMON Manuals