Module, Powertrain Control: Installation: 2.4L/3.2L

WARNING: This page is about a different car, the 2014 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Battery Tray, PCM Mount & Bolts

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

If a new powertrain control module is being installed, use a scan tool to reprogram the new module with the original vehicle identification number (VIN) and original mileage. If this step is not performed, a Diagnostic Trouble Code (DTC) will set.

If removed, install the PCM mount (3). Tighten the bolts (2) to 5 N.m (44 in. lbs.).

Fig 2: Powertrain Control Module Electrical Connectors & Nuts
Courtesy of CHRYSLER GROUP, LLC
Position the PCM onto the mount.
Install the ground wire. Tighten the nut (2) to 7 N.m (62 in. lbs.).
Install the nuts (3) Tighten to 7 N.m (62 in. lbs.).
Install the PCM electrical connectors.
Connect the battery negative cable.
NOTE:
If the module is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment.