LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2014 >> Challenger SXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Transmission Control Module (TCM) - Pre-Diagnostic Troubleshooting Procedure, Transmission Verification Test, TCM Programming Procedure & TCM Adaptation) >> Standard Procedure >> Transmission Verification Test-948TE >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Verification Test-948TE: Notes

WARNING: This page is about a different car, the 2014 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

To validate the repair(s) that fixed the vehicle, perform the following steps.

  1. Reconnect any disconnected components.
  2. Connect the scan tool to the Data Link Connector.
  3. With the scan tool, erase ABS DTCs.
  4. With the scan tool, erase PCM DTCs.
  5. With the scan tool, erase TCM DTCs.
    CAUTION:

    Apply the parking brake.

  6. With the scan tool, display the Transmission Temperature. Start and run the engine until the transmission temperature is above 43° C (110° F).
  7. If internal transmission components were repaired or replaced check the transmission fluid and adjust if necessary. Refer to the Check Oil Level procedure. Refer to FLUID AND FILTER, STANDARD PROCEDURE .
  8. If the Transmission Control Module (TCM), Valve Body, or Transmission without TCM was replaced, perform the Valve Body Solenoid Learn Procedure with a scan tool.
  9. If internal transmission repairs were performed or the Transmission Control Module (TCM) was replaced, perform the TCM ADAPTATION procedure. Refer to TCM ADAPTATION-948TE AND 9HP48 .
  10. After performing the above procedures, perform the "ROAD TEST PROCEDURE" below.
scientia non olet · About LEMON Manuals