Diagnostic Test

CHECK FOR DELAMINATION ON THE WINDSHIELD
1. Check the contact surface of the Rain Sensing Module to the windshield for delamination (this will resemble air bubbles in the contact area). and diagnose the FALSE WIPES (AUTOMATIC WIPER ONLY). Refer to DIAGNOSIS AND TESTING .
  Is a concern present with the windshield?
  
  Yes
  - Replace the windshield in accordance with the Service Information. Refer to WINDSHIELD, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 2
CHECK FOR AN ACTIVE DTC
NOTE:
Diagnose any LIN Bus DTCs set in the Body Control Module (BCM) before proceeding with this diagnostic procedure.
1. Turn the ignition on.
2. With the scan tool, read the DTCs.
  NOTE:
  If the (D402) LIN 2 Bus circuit is shorted to Ground or Battery voltage, this code may appear as Stored and when erased may return as Stored.
  
  Does the scan tool display DTC: B2211-00-LIGHT RAIN SENSOR MODULE INITIALIZATION PERFORMANCE as either active or stored?
  
  Yes
  - Go To 3
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
CHECK THE (D402) LIN 2 BUS CIRCUIT FOR A SHORT TO GROUND
1. Turn the ignition off.
2. Disconnect the Rain Sensor harness connector.
3. Measure the resistance between ground and the (D402) LIN 2 Bus circuit in the rain sensor connector.
  Is the resistance below 10k Ohms?
  
  Yes
  - Go To 5
  No
  - Go To 4
CHECK THE (D402) LIN 2 BUS CIRCUIT FOR A SHORT TO BATTERY
1. Turn the ignition on.
2. Measure the voltage between the (D402) LIN 2 Bus circuit and ground.
  NOTE:
  The voltage should fluctuate between approximately 7.0 and 9.8 volts.
  
  Is the voltage above 10.0 volts?
  
  Yes
  - Go To 6
  No
  - Replace the Light Rain Sensor in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (D402) LIN 2 BUS CIRCUIT FOR A SHORT TO GROUND
1. Disconnect the BCM G harness connector.
2. Measure the resistance between ground and the (D402) LIN 2 Bus circuit at the Rain Sensor harness connector.
  Is the resistance below 10k Ohms?
  
  Yes
  - Repair the (D402) LIN 2 Bus circuit for a short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the Light Rain Sensor in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (D402) BCM LIN 2 BUS CIRCUIT FOR A SHORT TO BATTERY
1. Turn the ignition off.
2. Disconnect the BCM G harness connector.
3. Turn the ignition on.
4. Measure the voltage between the (D402) BCM LIN 2 Bus circuit and ground.
  Is there any voltage present?
  
  Yes
  - Repair the (D402) LIN 2 Bus wire for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the Body Control Module in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .