Diagnostic Test

CHECK FOR RELATED DTCS
1. Turn the ignition on.
2. With the scan tool, read Memory Seat Module-Driver (MSMD) DTCs.
  Does the scan tool display any seat position sensor or circuit performance DTCs?
  
  Yes
  - Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
  No
  - Go To 2
CHECK IF THE DTC IS ACTIVE
1. Ignition on, engine not running.
2. With the scan tool, record and erase MSMD DTCs.
3. Cycle the ignition switch from off to on.
4. Move the seat in the full forward horizontal position.
5. With the scan tool, read MSMD DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - With the scan tool, perform the MSMD Standardization Routine.
  - Perform POWER SEAT SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform POWER SEAT SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .