LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2014 >> Durango SXT, AWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> 3.6L - DTCS P2115 To U1431 >> Diagnosis And Testing >> U0405-Implausible Data Received From Cruise Control Module >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. ACTIVE DTC 
    1. Cycle the ignition off, and back on.
    2. With a scan tool, view DTCs.

      Is the status Active or pending for this DTC?

      Yes 

      • Go To  2

      No 

  2. SPEED CONTROL SWITCH ASSEMBLY 
    1. Turn the ignition off.
    2. Replace the Speed Control Switch in accordance with the service information.
    3. Turn the ignition on.
    4. With the scan tool, erase DTCs.
    5. Cycle the ignition off, and back on.
    6. With the scan tool, view DTCs.

      Did the DTC return?

      Yes 

      • Go To  3

      No 

  3. STEERING COLUMN CONTROL MODULE 
    1. Turn the ignition off.
    2. Replace the Steering Column Control Module in accordance with the service information.
    3. Turn the ignition on.
    4. With the scan tool, erase DTCs.
    5. Cycle the ignition off, and back on.
    6. With the scan tool, view DTCs.

      Did the DTC return?

      Yes 

      • Go To  4

      No 

  4. POWERTRAIN CONTROL MODULE 
    1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the Steering Column Control Module and the Powertrain Control Module (PCM).
    2. Look for any chafed, pierced, pinched, or partially broken wires.
    3. Look for broken, bent, pushed out or corroded terminals.
    4. Monitor the scan tool data relative to this circuit and wiggle test the wiring and connectors.
    5. Look for the data to change or for the DTC to reset during the wiggle test.
    6. Perform any Technical Service Bulletins that may apply.

      Were any problems found?

      Yes 

      No