Diagnostic Test

PERFORM POWER SEAT SYSTEM VERIFICATION TEST 

1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
2. Make sure that all accessories are turned off.
3. Make sure that the battery is fully charged.
4. Turn the ignition on.
5. If either the Memory Seat Module (MSM) or the Driver Horizontal Seat Adjuster Motor/Seat Track was replaced, then the MSM Standard Routine must be performed using a scan tool.
6. Using a scan tool, record and erase Diagnostic Trouble Codes (DTCs) from all modules.
7. Operate the driver seat in all positions.
8. Using the Memory Switch on the driver's door, program the driver's seat number 1 Button to a desired position and the driver's seat number 2 Button to a different position.
9. Verify both Memory positions can be recalled with the Remote Keyless Entry (RKE) transmitter and with the Memory Switch on the driver's door.
10. Turn the ignition off, wait 10 seconds, then turn the ignition on.
11. Using a scan tool, select ECU View.
12. Check for DTCs in the modules.

    Are DTCs present in any of the modules or is the original condition still present?

    Yes 

    • The repair is not complete. Perform the appropriate diagnostic procedure for the DTC or symptom that is still present.

    No 

    • The repair is complete.