Module, Active Damping Control: Installation: Installation

Fig 1: Active Damping Control Module, Wire Harness Connectors & Screws

Courtesy of CHRYSLER GROUP, LLC

1. Place the Active Damping Control Module (ADCM) (1) into position on the mounting bracket.
2. Install and securely tighten the retaining screws (3).
3. Connect the wire harness (2) connectors to the ADCM (1).
4. Connect the negative battery cable.
5. Install the trunk floor pan cover.
6. Perform the ADCM Verification Test. Refer to STANDARD PROCEDURE .