Charging System (Service Information): Generator: Installation: 3.6L

Fig 1: Front Generator Mounting Retainer & Generator

Courtesy of CHRYSLER GROUP, LLC

1. Install the generator into the vehicle.
2. Install the three mounting retainers. Tighten to 25 N.m (18 Ft. Lbs.).
3. Install ground wire on mounting stud (4).
4. Install the lower front generator mounting retainer (5). Tighten to 23 N.m (17 Ft. Lbs)
5. Install the serpentine belt. Refer to BELT, SERPENTINE, INSTALLATION .
   Fig 2: Field Circuit, B+ Terminal Nut And Wire

   Courtesy of CHRYSLER GROUP, LLC
6. Install the B+ terminal to the generator stud. Tighten to 11 N.m (97 In. Lbs.).
7. Plug in the field circuit to the generator.
8. Connect the negative battery cable.