LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2015 >> Durango SXT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Electronic Control Modules (Service Information)) >> Standard Procedure >> Standard Procedure - Module Programming >> Programming The Pcm
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming The Pcm

WARNING: This page is about a different car, the 2014 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Read all notes and cautions for programming procedures.

  1. Connect a battery charger to the vehicle.
  2. Connect the scan tool.
  3. Have a unique vehicle PIN readily available before running the routine.
  4. Ignition key should be in RUN position.
    NOTE:

    If the PCM and WIN are replaced at the same time, the PCM MUST be programmed before the WIN. 

  5. Select "ECU View".
  6. Select "KIN Wireless Control".
  7. Select "Miscellaneous Functions."
  8. Select "PCM Replaced".
  9. Enter the PIN when prompted.
  10. Verify the correct information.
  11. Cycle ignition key after the successful routine completion.
scientia non olet · About LEMON Manuals