Program The Body Control Module

WARNING: This page is about a different car, the 2015 RAM ProMaster 3500, 2015 RAM ProMaster 2500, and 2015 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

During the Body Control Module (BCM) replacement procedure the original VIN and electronic code (key code) will be needed.

NOTE:

In some cases the vehicle may exhibit a start and stall condition after the BCM is replaced. If this occurs the key learn procedure may need to be ran and all keys relearned. Make sure that all keys are present if key relearn is required; keys not present will be locked out.

NOTE:

Once the new BCM is installed and diagnostic scan tool is launched, the normal network topology will not appear. Simply select BCM from the list menu and it will open into the normal ECU network topology view.

When replacing any module note the replacement and programming order. For more information, refer to MODULE REPLACEMENT AND PROGRAMMING ORDER GUIDE .

Ensure that the ignition is in and remains in the RUN position while performing this procedure
Select the BCM module from the "Vehicle View" screen
Select the Misc. Functions tab with the "BCM View" menu options
Select the BCM Replaced routine and click the start button
Follow the prompts on the screen to complete the procedure.