Program The TPM (Tire Pressure Monitor Module)
WARNING: This page is about a different car, the 2015 RAM ProMaster 3500, 2015 RAM ProMaster 2500, and 2015 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.
- With the scan tool, go to "Tire Pressure Module (TPM)", select "Miscellaneous Functions" and perform the Proxy Alignment procedure.
- With the scan tool, go to "Tire Pressure Module (TPM)", select "Data Display", read "'Tire Placard Pressure - Front" and "'Tire Placard Pressure -Rear" and confirm the values match the Tire Inflation Pressure (Placard) label. Also, go into the Body Control Module (BCM), select Data Display and read "'Tire Placard Pressure - Front" and "'Tire Placard Pressure -Rear" to confirm the values were programmed correctly. If the Placard values are incorrect in the BCM or TPM Module, select the Body Control Module (BCM) then under "Miscellaneous Functions", select "Update Pressure Threshold" and enter the placard pressure value as seen on the Tire Inflation Pressure (Placard) label. Program the Placard Pressure Values into the Tire Pressure Module (TPM).
- With the scan tool, erase all stored DTCs.
- Check for DTCs. If DTCs are present. Refer to DIAGNOSIS AND TESTING .