LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2016 >> ProMaster City SLT >> Repair and Diagnosis >> External Pages >> Different car >> Section 247 (3.6L - Intermittent Condition, Pcm/ECM Reprogramming - Gas, Powertrain Verification Test & Pre-Diagnostic Troubleshooting Procedure) >> Standard Procedure >> Pcm/ECM Reprogramming - Gas >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

WARNING: This page is about a different car, the 2015 RAM ProMaster 3500, 2015 RAM ProMaster 2500, and 2015 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.

If an NGC3 or NGC4 PCM was replaced, perform the following additional steps and/or routines: 

  1. PCM Replaced (if equipped with WCM)
  2. Learn ETC (if equipped with ETC)
  3. Check PCM VIN (if NOT equipped with WCM)
  4. Check PCM Odometer
  5. Quicklearn (if equipped with EATX)


If a GPEC PCM was replaced, perform the following additional steps and/or routines: 

  1. If the vehicle is equipped with a CVT, verify that the TCM has the latest software calibration available.
  2. PCM Replaced (if equipped with WCM)
  3. Learn ETC
  4. Check PCM Odometer
  5. Check PCM VIN (if NOT equipped with WCM)
  6. TCM Quicklearn (if equipped with EATX)


If a CVT TCM was replaced, perform the following additional steps and/or routines: 

  1. Initialize CVT


If an EGS TCM was replaced, perform the following additional steps and/or routines: 

  1. Initialize EGS
scientia non olet · About LEMON Manuals