Diagnostic Test
- DETERMINE ACTIVE OR STORED DTC
- Make sure the battery is fully charged.
- Turn the ignition on.
- Wait 12 seconds, then with the scan tool, read all active OCM DTCs.
Is the DIAGNOSTIC TROUBLE CODE (DTC) active or stored?
OCM - ACTIVE DTC
- Go To 2
OCM - STORED DTC
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
- CHECK BCM VEHICLE INFORMATION
- Using the scan tool, check for the correct Country Code, Vehicle Line, and Body Style.
Is the BCM programmed correctly?
Yes
WARNING:If the Occupant Classification Module (OCM) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment and may result in possible serious or fatal injury.
WARNING:Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- Replace the OCCUPANT CLASSIFICATION MODULE (OCM). Refer to MODULE, OCCUPANT CLASSIFICATION, REMOVAL .
- Perform the OCCUPANT CLASSIFICATION MODULE (OCM) VERIFICATION TEST. Refer to OCM REZERO .
No
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Using the scan tool, check for the correct Country Code, Vehicle Line, and Body Style.